You can see all references attached to the interface by navigating to System-Network-Interfaces and modifying the settings to show the Reference tab. ![]() The internal->WAN policy, and the DHCP server under the “Internal” interface. If you have a default config then there will be only two. So connect to a WAN or DMZ port and use the GUI, or make sure to be consoled into the firewall VIA the serial port (console).įirst we need to remove any reference to the “internal” switch itself. When we actually change the interface mode it will delete the IP address on the internal interface. In the next few parts we will change the switch mode to interface, and be able to add/remove ports and switches.īefore doing anything to the Firewall make a backup. ![]() In this mode you can add more switches, but not remove the current ports. The entry is written for a 90d, but will work the same for a 60d or 80d, even some C models.īy default the Fortigate is in “Switch mode” you will only be able to see the “internal” switch, and cannot add or remove interfaces from this switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |